2020 Audi Q2 MOT pass rate, common failures & what to check

In 2025, 90.3% of Audi Q2s first used in 2020 passed their MOT first time, against 86.0% for all cars first used in 2020. Across 44,471 Q2 first tests from 2023 to 2025, the most common failure areas were tyres, lamps and electrical equipment and brakes.

This page analyses first MOT tests for Audi Q2s first used in 2020 (all trims grouped): 2021 to 2025 for the pass-rate trend, and 2023 to 2025 for the failure and advisory analysis — plus what is worth checking before you buy one.

Data: DVSA anonymised MOT tests to December 2025 · Calculated by SortedCars · Updated October 2026

Passed first time, 2025
90.3%
of 14,653 first tests; all cars first used in 2020: 86.0%. Fixed-at-the-test counts as a fail
Tests analysed
44,471
first tests, 2023–2025; 14,653 in 2025
Clean pass, 2025
55.0%
of 14,653 first tests in 2025, passed with no advisory and no minor defect recorded
Typical mileage, tested in 2025
37,000
middle half: 27,500–48,000 miles; all cars first used in 2020: 37,500

How the 2020 Audi Q2 MOT pass rate has changed

Share of first tests passed in each year, Q2s first used in 2020 against all cars first used in 2020 (any make or fuel; not adjusted for mileage, fuel or use). In 2025 the Q2 figure was 4.3 points higher.

2020 Q2All cars first used in 2020
80%90%100%20212022202320242025Test year (first tests)All cars first used in 2020, test year 2021: 84.7%All cars first used in 2020, test year 2022: 90.2%All cars first used in 2020, test year 2023: 87.7%All cars first used in 2020, test year 2024: 86.9%All cars first used in 2020, test year 2025: 86%2020 Q2, test year 2022: 94.9%2020 Q2, test year 2023: 91.1%2020 Q2, test year 2024: 91.1%2020 Q2, test year 2025: 90.3%90.3%86%
View this chart as a table
Test year2020 Q2All cars first used 2020Q2 first tests
2021fewer than 500 tests84.7%15
202294.9%90.2%566
202391.1%87.7%15,054
202491.1%86.9%14,764
202590.3%86.0%14,653

Common 2020 Audi Q2 MOT failures

Share of the 4,070 failed first tests (2023–2025) with at least one failure in each area. A test can fail in more than one area, so the shares add up to more than 100%.

Tyres49.2%
Lamps, reflectors and electrical equipment18.5%
Brakes16.3%
Visibility12.6%
Noise, emissions and leaks5.9%
Seat belts and supplementary restraint systems3.8%
Suspension2.9%
Identification of the vehicle2.2%

Most common failure items

DVSA failure itemShare of failed first testsTests
Tyre condition: has a cut in excess of the requirements deep enough to reach the ply or cords19.4%790
Tread depth: below requirements of 1.6mm16.0%651
Brake pads: less than 1.5 mm thick11.3%459
Tyre condition: has ply or cords exposed5.7%234
Washers: provides insufficient washer liquid5.6%228

Item names are DVSA’s own wording. 2023–2025 combined.

What to check on a 2020 Audi Q2 before buying

The three areas where failed first tests most often had a fault, 2023–2025.

  1. Tyres. Worth checking the tread depth across the whole width of each tyre, and the sidewalls for cuts, cracks and bulges.
  2. Lamps and electrics. Ask someone to watch while you work the brake lights, indicators, sidelights, dipped and main beam, and the number-plate lamps.
  3. Brakes. Worth looking at the discs and pads through the wheel spokes for scoring and a worn lip, and noticing on the test drive whether the car pulls to one side or the pedal feels long.

Common 2020 Audi Q2 MOT advisories

Advisories are points the tester noted that did not fail the car. Most common on 2020 Q2s, as a share of all 44,471 first tests, 2023–2025.

DVSA advisory itemShare of first testsTests
Tyre condition: slightly damaged/cracking or perishing13.4%5,940
Tread depth: worn close to legal limit/worn on edge10.8%4,797
Brake pads: wearing thin9.1%4,054
Brake discs: worn, pitted or scored, but not seriously weakened4.5%2,007
Nail in tyre3.6%1,597

Questions about the 2020 Audi Q2 MOT

What is the MOT pass rate of a 2020 Audi Q2?

In 2025, 90.3% of Q2s first used in 2020 passed their MOT first time, against 86.0% for all cars first used in 2020. A car fixed during the test counts as a fail.

What does a 2020 Q2 most often fail its MOT on?

Tyres (in 49.2% of failed first tests, 2023–2025), lamps and electrical equipment (18.5%) and brakes (16.3%). The single most common item was “Tyre condition: has a cut in excess of the requirements deep enough to reach the ply or cords” (19.4%).

How often does a 2020 Audi Q2 fail its MOT?

In 2025, 9.7% of first tests on Q2s first used in 2020 did not pass first time: 7.7% failed, and a further 2.0% had a fault fixed during the test (counted as a fail here). Across 2023–2025, 4,070 of 44,471 first tests did not pass first time.

What are the most common 2020 Audi Q2 MOT advisories?

“Tyre condition: slightly damaged/cracking or perishing” (on 13.4% of first tests, 2023–2025), “Tread depth: worn close to legal limit/worn on edge” (10.8%), “Brake pads: wearing thin” (9.1%), “Brake discs: worn, pitted or scored, but not seriously weakened” (4.5%) and “Nail in tyre” (3.6%).

Is a 2020 Audi Q2 reliable?

An MOT pass rate shows what failed at the test, not how reliable a car is. For this group of cars the first-time pass rate went from 94.9% in 2022 to 90.3% in 2025. For one particular car, its own MOT history matters more than the average.

Other cars first used in 2020

The most-tested cars from the same year. Each page uses the same method.

2020 Ford Fiesta MOT statistics · 2020 Vauxhall Corsa MOT statistics · 2020 Volkswagen Golf MOT statistics · 2020 Ford Focus MOT statistics · 2020 MINI Hatch MOT statistics

How the 2020 Audi Q2 MOT data is calculated

Every number on this page is calculated by SortedCars from DVSA’s anonymised MOT test data for Great Britain, 2021–2025. “2020 Q2” means an Audi Q2 whose date of first use falls in 2020 (69, 20 and 70 plates), all trims grouped. Class 4 vehicles, first tests only — retests are not counted. Pass rate = passed ÷ all first tests; a car with a fault fixed during the test (PRS) counts as a fail. Our national first-test pass rate matches DVSA’s published figure (table DVSA/MOT/01) to within 0.04 points in every year. Clean pass = passed with no advisory and no minor defect recorded. Mileage is the reading recorded at the test. Comparisons are with all cars first used in 2020, any make or fuel, and are not adjusted for mileage, fuel or use. Failure and advisory item names are DVSA’s own wording. No figure is shown for fewer than 500 tests; an item is shown only if it appears on at least 50 tests and 1% of the base. Pass rates describe a group of cars, not one car: a well-kept example can pass and a neglected one can fail. This page is general information, not advice about any particular vehicle; always have a used car inspected before you buy. SortedCars is not affiliated with or endorsed by DVSA. You can check any car’s MOT history free on the official service: gov.uk/check-mot-history. Contains public sector information licensed under the Open Government Licence v3.0.